change a Flat Tire: A step-by-step guide to changing a tire. If a flat tire ever happens to you, you’ll need a properly inflated spare tire, a jack, and a lug wrench.
How do I change a Flat Tire On My Car
Pull off the road and out of the way of traffic. The best place to go is on a straight and level stretch of road, so you are easily visible to oncoming traffic. Once you’ve parked, turn on you hazard lights.
Take off the hub cap and use your lug wrench to loosen the lug nuts with a counterclockwise motion. (Don’t remove them completely yet.)
change a Flat Tire: Jack up the vehicle, Your vehicle’s owner’s manual will tell you the best place on the frame to position the jack, That spot is usually right behind a front tire and right in front of a rear tire. Raise the jack until it contacts the frame. Take a moment to ensure that your car is not leaning dangerously one way or another, then extend the jack another six inches.
Take the lug nuts off the bolts and place them aside.
Grasp the flat tire on each side and pull it towards you, off the axle.
Grab your spare tire and lift it in front of the wheel well. Line up the holes of the spare with the bolts on your vehicle. Push the tire onto the threaded bolts of your vehicle until it stops.
Replace the lug nuts on the bolts. Use the lug wrench to tighten them again, but only enough to hold the tire in place as you lower your vehicle to the ground.
Steadily lower the jack until all four tires are resting evenly on the ground, now, finish tightening the lug nuts on the spare tire.
change a Flat Tire: Put all of your tools back in your vehicle, turn off your hazard lights and center the flow of traffic again.